Related Manuals for Assa Abloy SL300
Summary of Contents for Assa Abloy SL300
- Page 1 Original instructions User Manual Entrance Systems Sliding Door Operator ASSA ABLOY SL300...
-
Page 2: Table Of Contents
Product liability ........................... Warranty ..............................Service ..............................Intended use ........................................................Technical specification ........................How the ASSA ABLOY SL300 works ....................Locking ..............................Unlocking ............................... Operation mode selectors ....................... PSK-6U - Modes ......................Integrated safety ..........................Safety system with presence sensors .................. - Page 3 Declaration of conformity ........................................................................................................... ASSA ABLOY as word and logo are trademarks owned by the ASSA ABLOY Group © ASSA ABLOY Entrance Systems, 2022 Technical data subject to change without notice. Backtrack information: folder:Workspace Main, version:a705, Date:2021-11-30 time:01:59:33, state: Frozen 1020882-en-5.0...
-
Page 4: Presentation Of Notes And Warning Signs
Presentation of notes and warning signs Various symbols and texts are used in this manual for easier understanding and identification. Note! When you see Note! it contains useful advice and information to ensure correct and compliant usage of the system. Potential hazardous situation that can lead to either minor or severe injuries or death and cause either minor or substantial property damage. - Page 5 WARNING: the drive shall be disconnected from its power source during cleaning, maintenance and when replacing parts. The operator can be used by children over 8 years of age if they have been instructed by a person in charge of their safety concerning use of the appliance in a safe way and understand the hazards involved.
- Page 6 Ensure that controls that can be set for a locked posi- tion are only activated when there are no other per- sons in the room. Issue 2022-03-16 1020882-en-5.0...
-
Page 7: Congratulations On Your New Automatic Door
Congratulations on your new automatic door! ASSA ABLOY Entrance Systems AB has developed automatic doors for more than 50 years. State-of- the-art technology and carefully tested materials and components provide you with a superior product. As with all other technical products, your automatic door requires periodic maintenance and service. -
Page 8: Warranty
ASSA ABLOY Entrance Systems-authorized resellers shall extend this warranty to end-users only, but have no authority to extend a greater or different warranty on behalf of ASSA ABLOY Entrance Systems. A service agreement with ASSA ABLOY Entrance Systems will help secure the availability of a fully operational system and will give priority at call-out, thus minimizing the time that the equipment is unusable. -
Page 9: Intended Use
The closing starts when no OPENING IMPULSE is received and the HOLD OPEN TIME has expired. The ASSA ABLOY SL300 user can select five different modes of operation if a programme selector is installed. See Operation mode selectors on page 1020882-en-5.0... -
Page 10: Locking
Locking Make sure that all people have left the building before locking the door. Unlocking Unlock all the mechanical locks before activating the operator. Operation mode selectors The door functions are set with operation mode selector. The operation mode selector is available with 5 positions (plus RESET). PSK-6U - Modes OPEN, AUTO PARTIAL, AUTO, EXIT and OFF modes can be obtained. -
Page 11: Integrated Safety
Integrated safety To permit a safe passage between closing doors, the doors reverse immediately if an obstruction is detected. They then resume their interrupted movement at low speed to check whether the obstruc- tion has disappeared or not. If an obstruction is detected while the door is opening, the doors stop immediately, and then close after a time delay. -
Page 12: Technologically Advanced Sensors
Technologically advanced sensors The ASSA ABLOY Entrance Systems sensors have been tested and approved by the ASSA ABLOY Entrance Systems test laboratory for use on ASSA ABLOY Entrance Systems's automatic sliding doors. These presence sensors further improve the already high obstruction detection obtained with the built in self-monitored crush force limitation. -
Page 13: How To Check Inner And Outer Combined Motion And Presence Detection Sensors
How to check inner and outer combined motion and presence detection sensors Combined sensors are used when you want both a motion sensor and a presence sensor integrated into the same unit. Walk towards the door opening, the door shall start to open when you are about 1.5 meter from the door and the door shall stop in open position. -
Page 14: How To Check Side Presence Detector(S)
How to check side presence detector(s) Side presence sensors can be used for example if higher door speed is required or for installations in homes for elderly/disabled or childcare centres, to protect users from being struck by the doors during their opening cycle. When a side presence sensor detects an obstacle the door operator will not stop, but slow down the door movement to a safe speed. -
Page 15: Regular Safety Checks
Check the safety sensors if any. page If you are unsure of which type of sensor you have, please contact your ASSA ABLOY Entrance Systems representative. Take appropriate measures. Contact your ASSA ABLOY Entrance Systems representative. For contact information, see last page. - Page 16 CLEANING The best way to remove dust and dirt from the ASSA ABLOY SL300 is to use water and a soft cloth or a sponge. A gentle detergent may be used. To maintain the quality of the surface treatment, the surfaces should be cleaned once/four months period.
- Page 17 Supervision of child (applied to both sides of the door): Mandatory according to national regulations. Recommended, if the risk analysis shows use by children. Local product label Contact your ASSA ABLOY Entrance Systems service representative. For contact information, see last page. 1020882-en-5.0...
-
Page 18: Safety Accessories
The door moves slowly Prevent traffic from using the door and allow it to close completely. Reset the operator by briefly pushing the reset button (see page 10). If the problem continues, please contact your ASSA ABLOY Entrance Systems representative. Issue 2022-03-16 1020882-en-5.0... -
Page 19: Service/Maintenance
Service and adjustments performed by your ASSA ABLOY Entrance Systems-authorized representative will ensure safe and proper operation of your automatic door unit. This product may contain batteries that should only be replaced by an ASSA ABLOY Entrance Systems-trained and skilled technician. - Page 20 Other standards or technical specifications, which have been applied: IEC 60335-2-103 ed.2 1:2011 IEC 60335-1 ed. 5:2010 DIN 18650-1:2010 Certificate issued by a notified or competent body (for full address, please contact ASSA ABLOY Entrance Systems AB) concerning the equipment: B 058029 0043 B.08490/20 The manufacturing process ensures the compliance of the equipment with the technical file.
- Page 22 Building on the long-term success of the Besam, Crawford, Albany and Megadoor brands, we offer our solutions under the ASSA ABLOY brand. Our products and services are dedicated to satisfying end-user needs for safe, secure, convenient and sustainable operations.