Enhanced Lock Kick, Fire Input And Extended Arm Selection (Level 5) - Assa Abloy SW300 Installation And Service Manual

16.6

Enhanced Lock Kick, Fire Input and Extended Arm Selection (Level 5)

a Disconnect batteries if any.
b Disconnect the mains.
c Press the LEARN BUTTON (LRN) and keep it depressed.
d Connect the mains.
e Watch the ERROR LED.
f Release the LEARN BUTTON after 5 flashes (LED is out).
g Identify the current lock kick status
The ERROR LED flashes an amount of short flashes that correspond to the status number.
After a short pause the LED will repeat the status number and so on.
h Changing the status
If you push the LEARN BUTTON once, the status number will increase. When you have reached
the highest status number it will start at number one again.
Level 5:
Lock-Kick Type
Fire-input **
Arm Selection
Lock-Kick Type
Fire-input
Arm Selection
Lock-Kick Type
Fire-input
Arm Selection
** When Fire-input is used all other configuration has to be done before selection of 12V, 24V
or 48V.
Basic Arm Selection
PUSH
PULL
PULL-220
Sliding PUSH
• Disconnect the mains
Next time the mains is connected, the operator will use the new status setting.
Fire Alarm signal, Uf, shall be selectable among: OFF,12 VDC, 24 VDC and 48 VDC. Uf shall be inter-
preted as ok, no fire alarm, in the following range: 0,85 x Uf to 1,2 x Uf. Reset same as KILL RESET.
1007913-en-20.0
1 (Default) 2
Basic Enhanced
OFF OFF
Basic Basic
7 8
Basic Enhanced
48V 48V
Basic Basic
13 14
Basic Enhanced
24V 24V
Extended Extended
Extended Arm Selection
00 -
10 PULL-600, 250 mm, -20-230
01 PULL-600, 420 mm, -20-230
11 -
Issue 2021-02-04
3 4
Basic Enhanced
12V 12V
Basic Basic
9 10
Basic Enhanced
OFF OFF
Extended Extended
15 16
Basic Enhanced
48V 48V
Extended Extended
16 Advanced settings
5 6
Basic Enhanced
24V 24V
Basic Basic
11 12
Basic Enhanced
12V 12V
Extended Extended
87