11 Mechanical installation
f
Mount the coordinator base (15) with the two screws (8) on the primary drive unit. Remove
the screw (9) and throw the washer (24) away when mount the acceptor (11) on the adjuster
(10). Mount the screw (9) through the acceptor (11).
g Mount the transmission unit. Adjust the adjuster (10) by turning until the primary door stops
at 15-18° from fully closed (this angle should be smaller than the electrical coordinator). Close
the door by pressing the linkage arm (14).
h Adjust the braking torque to > 50 Nm measured on the door leaf by turning one or both screws
(19).
58
Issue 2021-02-04
8
Screw
9
Screw
10
Adjuster
11
Acceptor
14
Linkage arm
15
Coordinator base
24
Washer
19
Screw
1007913-en-20.0