Service/Maintenance - Assa Abloy SW300 Installation And Service Manual

19 Service/Maintenance

19 Service/Maintenance
Regular inspections shall be made according to national regulations and product documentation
by an ASSA ABLOY Entrance Systems-trained and qualified technician. The number of service occa-
sions should be in accordance with national requirements and product documentation. This is
especially important when the installation concerns a fire-approved door or a door with an emer-
gency opening function.
As with all other technical products, an automatic door needs maintenance and service. It is essential
to know the importance of maintenance to have a reliable and safe product.
Service and adjustments will ensure a safe and proper operation of an automatic door unit.
The "Service Log Book" shall be used together with the "Site Acceptance Test and Risk Assessment"
document (PRA-0007) provided. Keep both documents available for maintenance and service re-
cords.
The table below shows the recommended interval in months, when to replace parts during pre-
ventive maintenance.
Adaptor kit
PUSH arm service kit
PULL slim service kit
Micro switch kit
Stop arm kit
Battery*
Transmission unit kit SW150
Transmission unit kit SW300
Control unit CU-300 without
EXU-boards
EXU-SI kit for security & im-
pulse
EXU-SA kit for safety
* Disconnect mains when replacing battery.
Risk of battery explosion if wrong type of battery is used. If Battery Monitoring DIP is ON, then
a reset of this is needed (after changed batteries), see page 18.
92
Part Part number
330000270BK/SI
330000271BK/SI
330000335BK/SI
331007845
331007849
33738753
331009148
331007819F
331008333
331003554
331003557
Issue 2021-02-04
Cycles/hour in operation
<10 <100 >100
Low Medium High
traffic traffic traffic
24 12 6
24 12 6
24 12 6
24 12 6
24 12 6
24 24 24
60 60 60
60 60 60
60 60 60
60 60 60
60 60 60
Abusive
Environment
6
6
6
6
6
24
60
60
60
60
60
1007913-en-20.0