Emptying The Solution Tank; Cleaning The Vacuum Tube; Cleaning The Water System Filter - COMAC Innova Comfort Use And Maintenance Manual

EMPTYING THE SOLUTION TANK

Proceed as follows to empty the solution tank:
1. Release the solution tank drainage tube (18), on the left-hand side of the machine, from its retainers (Fig.25). Remove the cap and place it on
the ground.
2. When the solution tank is empty, repeat the operations in the reverse order to reassemble all the parts.

CLEANING THE VACUUM TUBE

Careful cleaning of the vacuum hose guarantees better cleaning of the floor as well as a longer suction motor life. Proceed as follows to clean the
vacuum hose:
1. Remove the vacuum hose (1) from the vacuum nozzle (2) on the squeegee body (Fig.3).
2. Take the vacuum tube (1) out of the hole on the back of the recovery tank (Fig.26).
3. The vacuum hose from the retainers present inside the recovery tank.
4. Rinse the inside of the vacuum hose with a jet of running water.
5. Repeat the operations in reverse order to reassemble all the parts.

CLEANING THE WATER SYSTEM FILTER

In order to clean the water system's filter, do the following:
1. Shut off the tap output flow, then shift the knob (19) on the right-hand side of the steering column downward (Fig. 27).
2. Move to the front right-hand side of the machine and unscrew the detergent solution filter cap (20) (Fig. 88), then remove the cartridge from
the filter body.
3. Rinse the filter cartridge under a jet of water, and use a brush to eliminate any impurities, if necessary.
4. Once the filter cartridge is clean, repeat the operations in the opposite order to reassemble all the parts.
33