Table of Contents
Advertisement
1
1
2
ADJUSTING THE SQUEEGEE BODY'S RUBBER BLADES
The careful adjustment of the squeegee body rubber blades guarantees better cleaning of the floor.
To adjust the squeegee body blades, proceed as follows:
1. Sit on the driver's seat.
2. Insert the key (1) into the main switch on the control panel. Set the main switch to "I" (Fig.1).
3. For the manual machine versions, lower the squeegee body and rotate the lever (2) in the rear part of the steering column anti-clockwise
(Fig.2).
4. For the automatic machine versions, select the "DRYING" program then rotate the knob (4) on the control panel (Fig.3) as far as icon (B)
(Fig.4).
5. Press the drive pedal (4) (Fig.6) to begin moving the machine.
N.B.: For the automatic machine versions, the squeegee body will only begin to descend to its working position once the drive pedal has
been pressed.
N.B.: Once the squeegee body has reached its working position, the suction motor will enter into function.
6. As soon as the squeegee body is in its working position, carry out the steps to ensure machine safety; see the paragraph "MACHINE
SAFETY" on page 15.
ATTENTION: It is recommended to wear the appropriate PPE (Personal Protective Equipment), suitable for the work to be carried out.
7. Stand at the back of the machine.
Adjusting the height of the squeegee body:
8. Adjust the height of the rubber blade in relation to the floor by loosening or tightening the knobs (5) (Fig.7).
N.B.: By decreasing the distance between the squeegee support and the floor, the rubber blades present in the squeegee's body move
closer to the floor.
N.B.: the right-hand and left-hand knobs must be rotated the same number of times, so that the squeegee is parallel to the floor when it is
working.
Adjusting the tilt of the squeegee body:
9. Loosen the lock nut (6) on the squeegee tilt adjustment screw (7) (Fig.7).
10. To adjust the tilt of the squeegee body rubber blades in relation to the floor, tighten or loosen the screw (7) until the blades are bent outwards
by about 30° in relation to the floor, in an even manner along their entire length.
N.B.: Turning the screw (7) clockwise will increase the tilt of the squeegee body towards the rear of the machine, turn in the opposite
direction to rotate the squeegee towards the front of the machine.
11. As soon as the adjustment has been made, tighten the lock nut (6) on the squeegee tilt adjustment screw (7) (Fig.7).
ADJUSTMENT INTERVENTIONS
A
3
2
4
36
B
C
D
5
6
7
5
6
4
7
Hide quick links:
Advertisement
Table of Contents
