Working Programs; Transfer; Drying - COMAC Innova Comfort Use And Maintenance Manual

Scrubbing machines

Table of Contents

TRANSFER

The machine can be moved from one work area to another when the "transfer" working program is enabled. The only main actuator active is that

of the traction motorwheel.

To activate the "transfer" program on a manual machine, proceed as follows:

1. Raise the squeegee body and rotate the lever (1) on the back of the steering column clockwise (Fig.1).

2. Raise the brush head body and rotate the lever (2) on the back of the steering column anti-clockwise (Fig.2).

To activate the "transfer" program on an automatic machine, proceed as follows:

1. Use the knob (3) (Fig.3) to select the "transfer" working program (A) (Fig.4).

N.B.: The screen that will appear on the control display is the one shown in Fig.7.

DRYING

When the "drying" working program is enabled, the previously washed floor area can be dried.

To activate the "drying" program on a manual machine, proceed as follows:

1. Lower the squeegee body and rotate the lever (1) on the back of the steering column anti-clockwise (Fig.5).

2. Raise the brush head body and rotate the lever (2) on the back of the steering column anti-clockwise (Fig.2).

N.B.: If a reverse movement is made while this program is active, remember to raise the squeegee by rotating the lever (1) clockwise

(Fig.1).

To activate the "transfer" program on an automatic machine, proceed as follows:

1. Use the knob (3) (Fig.3) to select the "transfer" working program (B) (Fig.4).

N.B.: The main actuators active are those of the traction motorwheel and the suction motor.

N.B.: When the drive pedal is pressed, the squeegee is brought into working position (in contact with the floor) and the suction motor will

start working in full working order.

N.B.: If the machine is stopped and the drive pedal is released during the operation, the squeegee body will remain in contact with the floor

for a few seconds, after which it will raise up from the ground to go back to its rest position. For all these phases the suction motor will

continue to operate, only after a few seconds that it has returned to its work position will it switch off, this is to allow the motor to collect all

the liquid in the vacuum hose.

N.B.: During these phases, the symbol of the suction motor on the instrument panel display will blink, and it will only stop when the

squeegee is in its rest position and the suction motor is off.

N.B.: If reverse is carried out with this program active, the squeegee will move to the rest position, the suction motor will keep working for a

pre-set time and then it will switch off.

N.B.: The screen that will appear on the control display is the one shown in Fig.8.

The drying without scrubbing operation should only be carried out if the machine was previously used to

carry out a scrubbing without drying operation.