Battery Charge Level Indicator; Working Forward Speed; Reverse Function; Recovery Tank - COMAC INNOVA 65 B M 2011 Use And Maintenance Manual

16. BATTERY CHARGE LEVEL INDICATOR

On the instrument panel of the machine there is a monitor (1) indicating (amongst other things) the battery
charge status. If the upper line contains 8 light indicators, the battery charge level is 100%. If the edges of
the indicators are flashing, this means the batteries are run down.
ATTENTION: a few seconds after the last indicator on the monitor has flashed,
the brush motor will automatically switch off. With the remaining charge it is
possible to complete the drying process before recharging

17. WORKING FORWARD SPEED

This machine is equipped with electronic traction control.
To move the machine, after having turned the key in the ON position, push the drive pedal (6) adjusting
the speed by pressing and releasing the pedal. The machine will then start moving.

18. REVERSE FUNCTION

To make a reversing manoeuvre, press both pedals (6 and 7) the machine will then start moving
backwards. During reverse motion, the machine emits an acoustic signal.

19. RECOVERY TANK

Make sure the recovery tank is empty, otherwise empty it completely.
Check the cap of the drainage tube (10) (on the rear of the machine) is correctly closed.

20. SOLUTION TANK

The recovery tank must be completely empty each time the solution tank is filled.
Remove the front inlet cap and check the solution filter is correctly fitted.
Check that the solution filter cap (1), under the solution tank in the front right of the machine, is properly
closed.
MACHINE PREPARATION
16
1
1