Scrubbing With Drying; Scrubbing Without Drying - COMAC Innova Comfort Use And Maintenance Manual

SCRUBBING WITH DRYING

With the selector in the scrubbing with drying mode it is possible to both scrub and dry the floor at the same time.
To activate the "scrubbing with drying" program on a manual machine, proceed as follows:
1. Lower the squeegee body and rotate the lever (1) on the back of the steering column anti-clockwise (Fig.5).
2. Lower the brush head body and rotate the lever (2) on the back of the steering column clockwise (Fig.6).
To activate the "scrubbing with drying" program on an automatic machine, proceed as follows:
1. Use the knob (3) (Fig.3) to select the "transfer" working program (C) (Fig.4).
N.B.: The screen that will appear on the control display is the one shown in Fig.9.
N.B.: The main actuators active are those of the traction hub motor brush head gearmotors and suction motor .
N.B.: When the drive pedal is pressed, both the brush head and the squeegee will move to the working position, and as soon as it is in
contact with the ground the brush head gearmotors and the suction motor start working in full working order.
N.B.: If the machine stops and the foot pedal is released during the operation, the brush head body will start to rise to return to the rest
position, and after a period of time the gearmotors will switch off. The squeegee body will stay in contact with the floor for a few seconds,
after which it will raise up from the ground and return to its rest position.
N.B.: For all these phases the suction motor will continue to operate, only after a few seconds that it has returned to its rest position will it
switch off, this is to allow the motor to collect all the liquid in the vacuum hose.
N.B.: During these phases, the symbol of the suction motor on the instrument panel display will blink, and it will only stop when the
squeegee is in its rest position and the suction motor is off.
N.B.: If reverse is carried out with this program active, the squeegee will move to the rest position, the suction motor will keep working for a
pre-set time and then it will switch off.

SCRUBBING WITHOUT DRYING

With the selector in scrubbing without drying mode, it is possible to scrub the floor without vacuuming the detergent solution applied.
To activate the "scrubbing without drying" program on a manual machine, proceed as follows:
1. Raise the squeegee body and rotate the lever (1) on the back of the steering column clockwise (Fig.1).
2. Lower the brush head body and rotate the lever (2) on the back of the steering column clockwise (Fig.6).
To activate the "scrubbing without drying" program on an automatic machine, proceed as follows:
1. Use the knob (3) (Fig.3) to select the "transfer" working program (D) (Fig.4).
N.B.: The screen that will appear on the control display is the one shown in Fig.10.
N.B.: The main actuators active are those of the traction hub motor and the brush head gearmotors.
N.B.: When the drive pedal is pressed, the brush head will move to the working position, and as soon as it is in contact with the ground the
brush head gearmotors start working in full working order.
N.B.: If the machine is stopped and the drive pedal released during the work, the brush head body will start to rise in order to return to its
idle position, and after a period of time the gearmotors will switch off.
24