Assembling The Squeegee Body; Assembling The Brush Head Body Brushes; Inserting Water System Filter - COMAC Innova Comfort Use And Maintenance Manual

ASSEMBLING THE SQUEEGEE BODY

For packaging reasons, the squeegee body comes disassembled from the machine. To assemble it on the squeegee body support, proceed as
follows:
1. Carry out the steps necessary to secure the machine, see paragraph "MACHINE SAFETY" on page 15.
CAUTION: It is recommended to wear the appropriate PPE (Personal Protective Equipment), suitable for the work to be carried out.
2. Unscrew the knobs (23) in the squeegee body pre-assembly (Fig.24).
3. Insert the left-hand pin (24) on the squeegee body in the left-hand slit (25) in the squeegee support (Fig.25), making sure that the washer and
spring adhere in the upper part of the squeegee support.
4. Repeat the same operation for the right pin.
5. Tighten the knobs (23), making sure that the washer and spring adhere in the upper part of the squeegee support (Fig.26).
6. Insert the vacuum tube (26) in the sleeve (27) in the squeegee body (Fig.27).
N.B.: The squeegee has been adjusted beforehand; however, should you need to adjust it again, see paragraph "ADJUSTING THE
SQUEEGEE BODY'S RUBBER BLADES" on page 36.

ASSEMBLING THE BRUSH HEAD BODY BRUSHES

The machine is supplied without brush head brushes. To insert them into the brush holder plates in the brush head body, perform the following:
1. Carry out the steps necessary to secure the machine, see paragraph "MACHINE SAFETY" on page 15.
CAUTION: It is recommended to wear the appropriate PPE (Personal Protective Equipment), suitable for the work to be carried out.
2. Stand on the left side of the machine.
3. Insert the brush in its seat on the plate beneath the brush head, turning it until the three buttons enter the slots on the plate.
4. Turn in increments until the button is pushed towards the coupling spring and is locked in place (Fig.28).
N.B.: Image 28 indicates the direction of rotation for coupling the left brush; the right brush must be turned in the opposite direction.
5. Repeat the operations described for the right-hand front brush as well.

INSERTING WATER SYSTEM FILTER

Before using the machine for the first time the water system filter needs to be reset, for shipping reasons the filter cartridge and the cap have been
removed. To insert the filter cartridge in the water system filter body proceed as follows:
1. Take the machine to the maintenance area.
2. Carry out the steps necessary to secure the machine, see paragraph "MACHINE SAFETY" on page 15.
CAUTION: It is recommended to wear the appropriate PPE (Personal Protective Equipment), suitable for the work to be carried out.
3. Shut off the output flow from the tap and shift the knob (28) on the left-hand side of the steering column (Fig.29) upwards.
4. Move to the front of the machine and insert the filter cartridge (29) in the housing on the cap (10) (Fig.30).
N.B.: The O-ring gasket in the filter cartridge should be inserted into its seat in the cap.
5. Screw the cap (10) onto the body of the detergent solution filter (30) (Fig.31).
19