Starting Work - COMAC Innova Comfort Use And Maintenance Manual

1
1
2
4
6 7
A
B
C
D
11
To begin working with a manual machine, proceed as follows:
1. Carry out all the checks listed in the chapter "PREPARING TO WORK" on page 20.
2. Sit on the driver's seat.
3. Move the main switch to position "I" and make a quarter turn clockwise with the key (1) (Fig.1).
4. At switch-on, a number of screens appear in sequence on the display.
N.B.: In the first screen the nominal battery voltage programmed into the control board is displayed on the left of the screen, and on the right,
the minimum inhibit temperature appears (Fig.2).
N.B.: The second screen displays the hours of work completed by the machine (Fig.3).
5. The steps for a complete scrubbing and drying cycle are explained below - read the WORKING PROGRAMS chapter.
6. Lower the squeegee body and rotate the lever (2) on the back of the steering column anti-clockwise (Fig.4).
7. Lower the brush head body and rotate the lever (3) on the back of the steering column clockwise (Fig.5).
8. Make sure the detergent solution tap is completely open. If this is not the case, shift the knob (4) on the right-hand side of the steering column
downwards (Fig.6).
9. Press the drive pedal (5) (Fig.7) to begin moving the machine.
N.B.: Once the drive pedal is pressed, the brush head body and the squeegee body will begin to descend into their working positions.
N.B.: Once the brush head body and the squeegee body have reached their working positions, the relative motors will enter into function,
and the solenoid valve will dispense the detergent solution.
N.B.: During the first few metres, check that the amount of detergent solution coming out is suitable for the task in hand. If it isn't, adjust it
after reading the section "REGULATING THE DETERGENT SOLUTION FLOW".
10. The machine will now begin to work with full efficiency until the battery is flat or until the detergent solution has finished.
To begin working with an automatic machine, proceed as follows:
1. Carry out all the checks listed in the chapter "PREPARING TO WORK" on page 20.
2. Sit on the driver's seat.
3. Move the main switch to position "I" and make a quarter turn clockwise with the key (1) (Fig.1).
4. At switch-on, a number of screens appear in sequence on the display:
• The first screen displayed indicates the logo of the manufacturer of the machine.
• The second screen displayed indicates the name of the machine.
• The third screen displayed (Fig.8) indicates the characteristics of the machine's programming.
• The forth screen displays (Fig.9) identifies the work panel.
5. The steps for a complete scrubbing and drying cycle are explained below - read the WORKING PROGRAMS chapter.
6. Use the knob (6) (Fig.10) to select one of the following working programs (Fig.11):

STARTING WORK

3
8
5
21
3
2
4
9
5
6
10