Preparing To Work - COMAC Innova Comfort Use And Maintenance Manual

Scrubbing machines
Table of Contents

Advertisement

1
2
1
2
7
6
8
7
8
Before beginning to work, it is necessary to:
1. Make sure the recovery tank is empty; if not, empty it completely. See paragraph "DRAINING THE RECOVERY TANK" on page 31.
2. Check that the quantity of detergent solution in the solution tank is correct for the type of work to be carried out; if not, refill the solution tank -
see "FILLING THE SOLUTION TANK WITH WATER" on page 17 and "DETERGENT SOLUTION" on page 18.
3. Check the level tube (1) located near the operator's seat (Fig.1).
4. Check that the squeegee rubber blades are in a suitable condition for performing the work; if this is not the case, replace them. See paragraph
"REPLACING THE SQUEEGEE BODY RUBBER BLADES" on page 34.
5. Check the brush is in good working condition. If it isn't, replace it - see "REPLACING THE BRUSH HEAD BODY BRUSHES" on page 34.
6. Check that the machine is off, otherwise set the main switch to position "0" by turning the key (2) a quarter turn anti-clockwise (Fig. 2).
Remove the key from the instrument panel.
7. Unhook the tank rotation latch (3) (Fig.3) and turn the recovery tank into the maintenance position (Fig.4).
8. Connect the battery connector to the machine's main system connector.
ATTENTION: This process must be carried out by qualified personnel.
9. Rotate the recovery tank into the work position. Block the rotation with the latch (3).
10. Check that the solution tank drainage pipe cap (4) is closed. If this is not the case, close it (Fig.5).
11. Make sure the cap of the recovery tank drainage tube (5) is closed. If it isn't, close it (Fig.6).
12. Make sure the water system filter cap (6) is closed. If it isn't, close it (Fig.7).
13. Make sure the vacuum tube (7) is correctly connected to the sleeve (8) in the squeegee body. If it isn't, connect it (Fig.8).
14. Check that the recovery tank cover (9) is correctly positioned, otherwise position it correctly in the upper part of the recovery tank (Fig.9).

PREPARING TO WORK

3
3
4
9
9
20
4
5
6
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents