Battery Charger Connection (Versions With Cb) - COMAC INNOVA 65 B M 2011 Use And Maintenance Manual

To connect the batteries you must:
1. Make sure the recovery tank is empty, otherwise empty it completely
2. Make sure that the key switch is in the "OFF" position
3. Move the machine near to the battery charger
4. Engage the parking brake
5. Grip the handle under the seat to open the recovery tank
6. Lift the recovery tank until it hooks to the end of the safety clamp
7. Disconnect the electrical connector from the battery connector (1) from the machine connector (2)
8. Connect the battery charger cable connector
9. Close the recovery tank until the prop is hooked in the first point of the safety stop
The coupling connector of the battery charger is consigned inside the bag containing this instruction
booklet, and must be assembled on the cables of the battery charger as indicated in the instructions.
ATTENTION: this process must be carried out by qualified personnel. An
incorrect connection of the connector may cause problems with machine
functioning.
10. Connect the recently wired cable to the external battery charger
WARNING: Carefully read the use and maintenance instructions of the battery
charger that is used for charging. In addition, check that the battery charger is
compatible with the batteries used.
WARNING: Keep the recovery tank open for the duration of the battery
recharging cycle to allow gas fumes to escape
11. After recharging the batteries completely, the battery connector (1) must be connected to the
machine connector (2)
ATTENTION: danger of exhalation of gas and leakage of corrosive liquids.
ATTENTION: danger of fire: do not go near with free flames

15. BATTERY CHARGER CONNECTION (VERSIONS WITH CB)

In order not to cause permanent damage to the batteries it is essential to avoid their complete discharge:
arrange the recharge within a few minutes of the switching on of the flashing "discharged batteries" signal.
ATTENTION: never leave the batteries completely discharged, even if the
machine is not being used. Check the battery charger is suitable for the
batteries installed, in terms of both capacity and type.
MACHINE PREPARATION
14