ATTENTION! Whenever problems during operating occur, lower promptly the
lever of the emergency brake placed on the rear right side of the machine. This
command will block immediately the traction of the machine. To restart the
machine again, press the releasing trigger and lift the lever of the emergency
brake; then push forward the lever on the handle bar.
2. SQUEEGEE AUTOMATIC-MANUAL
The machines with automatic version have the possibility to control electrically the squeegee movement.
Depending on the position of the switch (1) the following functioning systems are activated.
Automatic If the switch is placed on automatic, lowering of the squeegee and starting of the suction
motor are obtained with the machine advancement. Also, lifting of the squeegee and
stopping of the suction motor are achieved with the reverse motion of the machine.
Manual
If the switch is placed on manual, the squeegee lifts and lowers itself manually through the
commutator (2). The operation of the suction motor is commanded anyhow through the
squeegee.
3. BRUSHES PRESSURE MANUAL
Brushes pressure can be adjusted through the lever shown in the figure. There are three predetermined
positions. Major is the pressure when the lever is in the highest position.
The pressure must be chosen based upon the type of floor and the type of dirt. Excessive pressure
causes higher brushes wear and major energy consumption.
4. BRUSHES PRESSURE WITH AUTOMATIC CONTROL
n case of machines equipped with automatic control (machines with actuator), the lever for the adjustment
of the brushes pressure allows four different levels. Also in this case, major is the pressure onto the
brushes when the lever is in its highest position.
WORK
15
AUTO MAN
1
2