Table of Contents
Advertisement
Parameterization
8.2 Application
program name "Modified" indicates which program was open and modified when the
connection was interrupted.
You may wish to save these changes immediately, since the changes will be lost if the connection
is terminated again or the program is changed.
Table 8-7
Program steps & program-specific toolbar
Button
Program
Image acquisition
CenSOR
Note
Change the camera to processing mode on completion of parameterization
On completion of parameterization, the camera needs to be changed to processing mode.
Only then does the cyclic processing of the acquired reflector images and communication with
the controller start.
Description of the page layout with three columns
Table 8-8
Page layouts
Column
Right-hand column
③
Image and result views
Middle column
Display of image and results
Left-hand column
⑤
Parameter area
70
Description
Click this button to go to the "Program" program step.
Click this button to go to the "Image acquisition" program step.
Click this button to go to the "CenSOR" program step.
Description
The settings for the image and result views are shown in this column. If the camera is in
processing mode ("Start"), the additional results are displayed.
This column shows the image that was acquired last or the current image as well as the
④
associated results
The various parameters are shown in this column.
②
SIMOCRANE CenSOR
Operating Instructions, 07/2021
Advertisement
Table of Contents
