Table of Contents
Advertisement
Commissioning
7.2 Connecting the camera
Step 2: Switch on the camera
Switch on the power supply to the camera.
• Camera version 1 (indoor crane) is powered via the Power-IO-RS232 cable.
• Camera version 2 (outdoor crane) is powered via the power supply cable of the stainless steel
housing.
Note
Camera self-test
Note that a self-test is performed each time the camera is started. The self-test is indicated by
flashing of the power LED and lasts from a few seconds to 2 minutes. When the test is complete,
the power LED emits a steady green light and the camera is ready for operation.
Step 3: Configure the Ethernet connection between the camera and PC
1. Start PRONETA Basic. The PRONETA main menu is displayed.
Figure 7-1
2. Click "Settings". Then open "Network Adapter" and select the adapter
of your PC/programming device which is connected to the camera. Then click "Home" to
return to the main menu.
Figure 7-2
50
PRONETA - Main menu
PRONETA - Network Adapter
SIMOCRANE CenSOR
Operating Instructions, 07/2021
Advertisement
Table of Contents
