Table of Contents
Advertisement
Chapter
What needs to be done?
Application
SIMOCRANE CenSOR commissioning (applies to both versions)
(Page 67)
→ Settings → Options
→ Application → Program
→ Application → Program → Image acquisi‐
tion
→ Application → Program → CenSOR
→ Application → Program
Calibration (Page 86) → Libraries → CenSOR calibration
Connection to a con‐
Connect SIMOCRANE CenSOR to a controller
troller (Page 119)
Checklist "Installation/connection", "Application", "Calibration", "Connection to a controller"
SIMOCRANE CenSOR
Operating Instructions, 07/2021
A.2 "Commissioning" checklist for SIMOCRANE CenSOR
•
"Lighting" group - select lamp
•
"Lens" group - set the focal length
•
Create a new program or select an existing
program
"Image" group - set exposure time and bright‐
ness
"Trigger" group - set acquisition interval
"Lighting" group - select lamp and activate
flash (if installed)
"Reflector parameters" group → set the following pa‐
rameters:
•
Main reflector, Reflector alignment
•
Main reflector, Reflector size
•
Activate additional reflector (if installed)
•
Additional reflector, Reflector size (if nec‐
essary)
"Image processing parameters" group → set the fol‐
lowing parameters:
•
Minimum reflector contrast
•
Edge determination threshold
•
Probability of detection
•
Edge smoothing filter
•
Activate exposure control
•
Control Gain
•
Amount of Brightness
"Measured values for parameters" group → set the fol‐
lowing parameters:
•
Activate "External Distance" input value (if
required)
•
Determine and enter scale and offset for
external distance (if necessary)
•
Offset and smoothing time for all meas‐
ured values
•
Reflector distance limit
•
Save program and start processing
•
Perform the calibration steps
•
Connect SIMOCRANE CenSOR via PROFI‐
NET IO (Page 120)
•
Connect SIMOCRANE CenSOR with UDP
via Ethernet (Page 128)
Appendix
OK?
151
Advertisement
Table of Contents
