Adding A Phone - D-Link VoiceCenter DVX-2000MS User Manual

Section  - Installation

Adding a Phone

When you add a phone to Response Point, you physically connect the device to the LAN and to a power source, as
well as configure it using the Configure Phone Wizard. During the configuration process, you must assign one user to
it. If the phone supports a primary user, the user must be the primary user.
To add a phone
1. Click the Phone System button.
2. In the Tasks panel, under Phones, click Add Phone, which displays the Configure Phone Wizard.
3. Confirm that the phone is connected and plugged in, select the check box at the bottom of the Have you connected
your phone page, and click Next.
4. On the What phone do you want to add page, click the phone you just connected.
Note: If you do not see the phone that you just connected, click Refresh in the Tasks panel. If you still do not see the
phone, make sure that the phone is connected to the LAN, unplug the phone from the power source, and plug it back
in. After plugging in the phone, you may need to wait at least sixty seconds before the phone is initialized and ready
to be configured.
5. Click Next to display the Who will receive calls on this phone page.
To configure a user on the phone that you added
1. Click Assign User to select an existing user, and click OK. Or, to add a new user, click New User at the bottom of
the Administrator - Select dialog box, and type the correct information on the Identification tab.
2. Click Next.
D-Link DVX-000MS User Manual