DES-3350SR Layer 3 Fast Ethernet Switch User's Guide
config ospf ipif
Purpose
Used
settings.
Syntax
config ospf [ipif <ipif_name 12>/all {area
<area_id>|priority <value>|hello_interval
<sec 1-65535>|dead_interval <sec 1-
65535>|authentication [none|simple
<password 8>|md5 <key_id 1-
255>]|metric <value>|state
[enabled|disabled]}
Description
This command is used to configure the
OSPF interface settings.
<ipif_name 12> − The name of the IP
Parameters
interface.
priority <value> − The priority used in the
election of the Designated Router (DR). A
number between 0 and 255.
metric <value 1-65535> − The interface
metric (1 to 65535). Entering a 0 will allow
automatic calculation of the metric.
hello_interval <sec 1-65535> − Allows the
specification of the interval between the
transmission of OSPF Hello packets, in
seconds.
can be specified. The Hello Interval, Dead
Interval,
Authorization Key should be the same for all
routers on the same network.
dead_interval <sec 1-65535> − Allows the
specification of the length of time between
to
configure
the
OSPF
Between 1 and 65535 seconds
Authorization
344
interface
Type,
and