Table of Contents
Advertisement
DES-3350SR Layer 3 Fast Ethernet Switch User's Guide
Each command is listed, in detail, in the following sections.
create route redistribute dst ospf
Purpose
Used to add route redistribution settings for
the exchange of RIP routes to OSPF routes
on the switch.
Syntax
create route redistribute dst ospf src
[static|rip|local] {mettype [1|2]|metric
<value>}
Description
This command will redistribute routing
information between the OSPF and RIP
routing protocols to all routers on the
network that are running OSPF or RIP.
Routing information entered into the Static
Routing Table on the local DES-3350SR
switch is also redistributed.
Parameters
src
selection of the protocol for the source
device.
dst − Allows for the selection of the protocol
for the destination device.
mettype [1|2] − Allows for the selection of
one of two methods of calculating the metric
value. Type-1 calculates (for RIP to OSPF) by
adding the destination's interface cost to the
metric entered in the Metric field. Type-2
uses the metric entered in the Metric field
without change. This field applies only when
the destination field is OSPF.
−
[static|rip|local]
Allows
198
for
the
Advertisement
Table of Contents
