Table of Contents
Advertisement
Crestron STX-1700CXPW
Operations Guide – DOC. 6249A
Wall Mount 2-Way RF Wireless Touchpanel
4. Refer to the diagram below. By hand, undock the touchpanel by pulling
the upper edge of the touchpanel outward and remove the touchpanel.
Remove STX-1700CXPW
5. Refer to the diagram below. Re-install the access hole plug into the
access hole.
Re-Install Access Hole Plug
Identity Codes
The STX-1700CXPW touchpanel uses distinct types of identity (ID) codes for
recognition within a Cresnet system: Cresnet identity (Net ID) for instances when the
touchpanel is wired to the Cresnet system, and RF ID for those instances when the
touchpanel communicates with the Cresnet system via the RF gateway. These codes
are assigned to the touchpanel from the SELECT INTERFACE screen when the unit
is configured. Refer to "Select Interface" on page 14. These assignments must match
assignments made in the SIMPL Windows project.
In addition, it is necessary to specify an RF channel and band in order for the
touchpanel and TPS-RFGWX gateway to communicate. These settings, described
briefly on the next page, are assigned via the RF SETUP and ADDITIONAL RF
SETUP screens, shown on pages 14 and 15, respectively.
Wall Mount 2-Way RF Wireless Touchpanel: STX-1700CXPW • 11
Advertisement
Table of Contents
