Table of Contents
Advertisement
1-Way Wireless RF Touchpanel
MAIN MENU
This menu can also be obtained via
digital reserved join number, 17242.
6 • 1-Way Wireless RF Touchpanel: ST-1700C
ST-1700C Power Source Options
POWER SOURCE OPTION
Battery Pack**
Docking Station
Domestic External Power Pack or
International External Power Pack
*
The latest revision may have a revision letter after the document number (i.e., 6088A)
**
The battery pack does not "trickle" charge when the external power pack is used to power the
touchpanel.
Identity Codes
The ST-1700C touchpanel uses two distinct types of identity codes: Cresnet identity
(Net ID or Cresnet ID), and RF ID. These codes are assigned to the touchpanel from
the Interface Submenu when the unit is configured. Refer to "Setup Menu" on page
7. For the touchpanel to be identified within the Cresnet system, these assignments
must match assignments made in the SIMPL Windows program.
Net ID
Every equipment and user interface within the Cresnet system requires a unique Net
ID. The Net ID is a two-digit hexadecimal number that can range from 03 to FE. The
Net ID of the unit must match the Net ID specified in the SIMPL Windows program.
The Net ID is used when the touchpanel is wired directly to the control system
during uploading a Crestron VisionTools
touchpanel firmware.
RF ID
Every ST-1700C touchpanel communicating with a Cresnet control system via a
CNRFGWA requires a unique RF ID to secure RF communications. There are 15
useable codes (two-digit hexadecimal numbers) for multiple touchpanel(s) ranging
from 10 to 0F in most significant digit increments (i.e., 10, 20, 30, . . . F0). The RF
ID of the unit must match the RF ID specified in the SIMPL Windows program.
NOTE: Do not set the RF ID to "00"; it is not supported in SIMPL Windows.
Configuring the Touchpanel
To configure the unit, it may be necessary to access a series of setup screens prior to
viewing run-time screens that are loaded into the touchpanel for normal operation.
The MAIN MENU for configuring the touchpanel appears when a finger is held to
the touchscreen for about five seconds from the powered down state.
Upon entering SETUP MODE, the MAIN MENU, shown to the left, displays four
buttons: Touch Screen Calibration, Exit and Run Program, Setup, and
Diagnostics.
The Exit and Run Program button verifies that all of the setup information has
been saved to EEPROM and displays the main page that has been programmed into
your system. The remaining buttons on the MAIN MENU open other menus, which
are discussed in subsequent paragraphs.
Crestron ST-1700C
DOCUMENT
MODEL
NUMBER *
ST-BTPN
6088
ST-DSN
6095
PW-1215
5762
PWI-1215
5763
®
Pro-e (VT Pro-e) project or upgrading the
Operations Guide – DOC. 6225A
.
Advertisement
Table of Contents
