Crestron STX-1700CXPW Operation Manual page 31

Wall mount 2-way rf wireless touchpanel

Hide thumbs Also See for STX-1700CXPW:

Table of Contents

Crestron STX-1700CXPW

Operations Guide – DOC. 6249A

Wall Mount 2-Way RF Wireless Touchpanel

NOTE: You can also dock the STX-1700CXPW in the DA-1700CW to upload or

upgrade the panel. However, Crestron recommends that you use the connections for

uploading or upgrading that are described on the next page.

Typical Connection Diagram when Uploading

NOTE: If the control system in use has a 4-pin network connector rather than a

modular (RJ-11-type) NET connector, use an ST-CBL interface cable (sold

separately).

NOTE: To make a cable for either configuration, refer to the "Programming Cable

Specifications" diagram after these notes.

NOTE: An adapter such as a CN-RJ11 (sold separately) is required when using the

RJ-11 cable.

NOTE: The RJ-11 (part of ST-PK) and ST-CBL cables can also be found as part

numbers CNSP-585 and CNSP-586, respectively, in the Crestron cable database. The

database can be downloaded from the Crestron website.

NOTE: The procedure on the next page uses the ST-CBL.

Wall Mount 2-Way RF Wireless Touchpanel: STX-1700CXPW • 27

Table of Contents