Table of Contents
Advertisement
Crestron STX-1700CXPW
Operations Guide – DOC. 6249A
Wall Mount 2-Way RF Wireless Touchpanel
Accessing the "Port Settings" Window
7. Select the RS-232 connection type. Verify the available COM is
selected. Verify that the baud rate is set to 115200 (PRO 2 default), the
parity is None, the data bits is Eight, the stop bits is One, XON/XOFF
is not selected, and RTS/CTS is selected. Click the OK button to save
the settings and close the window.
NOTE: If problems occur when transferring any Cresnet file (touchpanel
project/firmware), lower the port speed baud rate to 38400 to match the Cresnet bus
speed when transferring through a control system. Make sure XModem is selected
from Mode for Network Transfers.
"Port Settings" Window
8. Proceed to "Uploading a VT Pro-e Project" on the next page or
"Firmware Upgrade" that begins on page 31, as appropriate.
Wall Mount 2-Way RF Wireless Touchpanel: STX-1700CXPW • 29
Advertisement
Table of Contents
