Docking The Stx-1700Cxpw - Crestron STX-1700CXPW Operation Manual

Wall Mount 2-Way RF Wireless Touchpanel
8 • Wall Mount 2-Way RF Wireless Touchpanel: STX-1700CXPW

Docking the STX-1700CXPW

To dock the STX-1700CXPW, refer to the procedure below.
NOTE: Do not dock the STX-1700CXPW into the DA-1700CW without the
ST-BTPN being installed in the touchpanel. Operating power for the DA-1700CW is
supplied through the electrical contacts of the ST-BTPN. If the ST-BTPN is not
installed, the DA-1700CW will not electrically undock the touchpanel, it would have
to be manually undocked (refer to "Manually Undocking of Touchpanel" on page 9).
1. Refer to the diagram below. Insert the bottom edge of touchpanel
docking plate (located on the rear of the touchpanel) into DA-1700CW
directly behind the front panel.
Insert STX-1700CXPW
2. Refer to the diagram below. Make sure that the STX-1700CXPW is
squarely seated in DA-1700CW, and press upper edge of touchpanel
inward to dock the touchpanel. The touchpanel will snap into position.
Dock STX-1700CXPW
Crestron STX-1700CXPW
Operations Guide - DOC. 6249A