Table of Contents
Advertisement
Crestron STX-1700CXPW
Operations Guide – DOC. 6249A
Wall Mount 2-Way RF Wireless Touchpanel
Double-click the STX-1700 (Cresnet) icon in the upper pane to open the "Device
Settings" window. This window displays STX-1700 (Cresnet) device information.
Select the Net ID tab to change the touchpanel Net ID, as shown in the following
graphic.
"Device Settings" Window for the STX-1700CXP (Cresnet)
Similarly, double-click the BB/DA-1700CW and STX-RFGWX icons in the upper
pane to open their respective "Device Settings" windows. Select the Net ID tabs as
necessary to change the Net IDs.
Expand the system tree in the lower pane and double-click the STX-1700CXP icon to
open its "Device Settings" window. Select the RF/IR ID tab to change the touchpanel
RF ID. For more information on setting the RF/IR ID, refer to "RF Setup" shown on
page 14.
NOTE: SIMPL Windows automatically changes NET ID values of a device added
to a program if a duplicate device or a device with the same default NET ID already
exists in the program. Always ensure that the network device NET IDs set via
Viewport match the ones in your SIMPL Windows program.
STX-1700CXPW Symbol in Programming Manager
Programming Manager is where programmers "program" a Crestron control system
by assigning signals to symbols. The illustration on the next page shows the
STX-1700CXPW symbol in the SIMPL Windows' Programming Manager.
NOTE: SIMPL Windows uses essentially the same symbol for both the wired and
the wireless versions of the touchpanel, adding (Cresnet) to the name of the wireless
version to distinguish between them. In the following sections, the signal names and
definitions apply to both touchpanels. Except for instances where the touchpanel is to
perform certain functions in one configuration and not the other, copy the logic from
one symbol and paste it into the other.
Wall Mount 2-Way RF Wireless Touchpanel: STX-1700CXPW • 21
Advertisement
Table of Contents
