Table of Contents
Advertisement
Wall Mount 2-Way RF Wireless Touchpanel
SCREEN SETTINGS
- BRIGHTNESS
STARTUP PREFERENCE
POWER MANAGEMENT
TIMEOUT SETTINGS
10
16 • Wall Mount 2-Way RF Wireless Touchpanel: STX-1700CXPW
Brightness
From the SETUP MENU, press the Brightness button to open the SCREEN
SETTINGS – BRIGHTNESS screen. The UP and DOWN buttons increase and
decrease screen brightness, respectively. The area to the right of the buttons shows the
relative brightness from 0% to 100%. Note that the 0% setting will not completely
darken the LCD screen; it will still be faintly visible.
Select the Return button to return to the SETUP MENU.
Startup Preference
NOTE: This feature applies only to units with the optional pushbuttons installed.
Refer to "Appendix B: Installation of Optional Pushbuttons" for details.
The Startup Preference feature allows (when the touchpanel is off or in standby) the
display to come on or stay off when a "quick" pushbutton is pressed. From the
SETUP MENU, press the Startup Preferences button to open the STARTUP
PREFERENCE screen.
When pressed, the DISPLAY ON FROM HARDKEY button toggles between
ENABLED and DISABLED. With ENABLED selected, the display comes on when
one of the "quick" pushbuttons is pressed. With DISABLED selected, the display
stays off when a "quick" pushbutton is pressed (it goes to standby). The default is
DISABLED. Note that the button signal will be sent to the RF gateway if the
touchpanel is in standby mode.
NOTE: To successfully send a pushbutton command when the touchpanel display is
dark, the user may have to press the pushbutton twice, with a minimum two-second
interval between presses. This method is preferred because when a panel display is
inactive, the user cannot discern whether the panel is in a standby or power down
state. Furthermore, a single pushbutton press may not be transmitted, depending on
the state of the unit. For example, the DISPLAY ON FROM HARDKEY DISABLED
command in startup preferences ensures that the panel display remains inactive.
Select the Return button to return to the SETUP MENU.
Power Management Timeout Settings
The Power Management feature is intended to conserve energy, and to extend the
service life of the battery. From the SETUP MENU, press the Power Management
button to display the POWER MANAGEMENT TIMEOUT SETTINGS screen. Use
the STANDBY and POWER DOWN UP and DOWN buttons to set the respective
timeouts from 0 through 120 minutes, where 0 disables the timeout. It adjusts in one-
30
minute increments from 1 to 10, in ten-minute increments from 20-120.
Use the Standby Now and Power Down Now buttons to immediately enter the
respective mode.
STANDBY timeout turns the display and backlight off when the touchpanel is
inactive for the specified time. When the touchpanel is reactivated, the last screen to
be displayed reappears. The specified time is displayed in minutes. The default
STANDBY timeout is 10 minutes.
POWER DOWN timeout turns off all power when the touchpanel is inactive for the
specified time. When the touchpanel is activated, the first page of the project
appears. The specified time is displayed in minutes. The default POWER DOWN
Crestron STX-1700CXPW
Operations Guide - DOC. 6249A
Advertisement
Table of Contents
