Crestron CNX-DVP4 Operation Manual page 75

Crestron CNX-DVP4
Operations Guide – DOC. 8170A
SIMPL Windows Preferences – Special Symbol Set
iii. Drop in a CNX-DVP4 in to the project, then right click on Slot 1 of the
CNX-DVP4.
Select Device Extender
iv. Select Telestrator/Mouse Configuration.
v. Add an analog label (Crestron Mouse) to RGB1 for Touch-the-PC to work
on RGB input 1.
vi. Add an analog initialize. Set the analog value to zero and the analog out
label (Crestron Mouse). Add a 1 to the digital input.
vii. Load the program to the CNX-DVP4 or Pro 2, whichever unit is the master.
d. The "Touch the PC" should be working. If it is proceed to next step, if not
proceed to step f.
e. Perform the Calibration of the Touch-the-PC from the Icon in the Window tray
on the computer that has Serial mouse driver installed.
f. If the mouse movement works but you do not have left mouse clicks. Do the
following:
i.From the computer that has the Touch the PC driver installed select the Icon in
the Windows tray.
ii. Select Button mode tab: Edit mode should be Touch Down Left
iii.Select Events tab: Primary – contact – Touch Down Left
Digital Video Processor
Digital Video Processor: CNX- DVP4 • 69