Compact Flash Installation - Crestron CNX-DVP4 Operation Manual

Crestron CNX-DVP4
Operations Guide – DOC. 8170A
2. Position a rack ear so that its mounting holes align with the holes vacated
by the screws in step 1.
3. Attach the ear to the unit with three screws from step 1, as shown in the
following illustration.
Ear Attachment for Rack Mounting
Fasten with the same (3) cover screws.
Right side view of DVP4 with optional rack mounting ears installed.
4. Repeat procedure (steps 1 through 3) to attach other ear to opposite side.

Compact Flash Installation

The CNX-DVP4's onboard memory is enhanced with a 4GB expansion slot that
supports off-the-shelf Type II compact flash memory (a 32MB compact flash card is
provided) and the IBM Microdrive
panel of the unit (Memory Expansion). Complete the following procedure to install
the compact flash. Make sure power is disconnected before installing the compact
flash. Refer to the illustration following the procedure.
NOTE: Compact flash is a mass storage device contained in a small footprint. A
compact flash card is approximately the size of a matchbook.
1. Loosen the screw and remove the memory expansion cover located on the
back panel.
2. Observe handling precautions of the compact flash manufacturer and insert
it into the open slot.
3. Align and reposition cover over slot.
4. Tighten the screw.
Memory Expansion Slot Cover/Screw
COM 1 COM 2
VIDEO INPUT 1
B
A
COMP
C OM P
Y C
DVI/RGB

hard drive. The slot is accessible on the back
Memory slot cover/screw
COM 3 COM 4
MEMORY
EXPANSION
VIDEO INPUT 2
A B
OUTPUT
COMP COMP C OMP
Y C
DVI/RGB DVI/RGB
Digital Video Processor: CNX- DVP4 • 13
Digital Video Processor
TOUCHSCREEN
NET
LAN
MOUSE
COMPUTER
24 Y Z G
VIDEO INPUT 3 VIDEO INPUT 4
B
B A
A
COMP
COMP COMP
Y C
Y C
DVI/RGB
DVI/RGB