Using Tps-5000/6000 As A Touchscreen Mouse Connected Via Cresnet - Crestron CNX-DVP4 Operation Manual

Crestron CNX-DVP4
Operations Guide – DOC. 8170A
Using TPS-5000/6000 as a Touchscreen Mouse
Connected via Cresnet
Equipment required:
•
One DVP4 Version 3.017 or higher
•
One TPS-5000/6000 panel with an RGB card V1.017
•
One DVI to RGB adapter supplied by Crestron
•
One 24 VDC 75 watt power supply for DVP4
•
One VGA Male cable to VGA Male cable
•
One RS-232 cable Crestron P/N STPK programming kit.
•
Cresnet cables
Software Required:
•
Simple Windows Version 2.03.11 or higher
•
VTPro-e Version 3.0.0.6 or higher
1. Connect the RS-232 cable from the touchpanel to the CNX-DVP4
touchscreen/ mouse serial port.
2. Set up the touchpanel serial port for RS-232 PORT FOR TOUCH OUT.
3. Create a page In VT Pro-e with a full screen RGB window.
4. In the "RGB Properties" window, select the Design tab and select Pad 1 or
2.
5. From "Project Properties" select Pad Area tab and select Pad 1 or 2 for
Type: MOUSE and Communication via: SERIAL.
6. Send the project to the touchpanel.
7. In Viewport, set the CNX-DVP4 to Touch command # 8 (Crestron Tablet).
8. Perform Calibration from Viewport via the CALTOUCH command.
NOTE: Each time a new touchscreen is connected to the Touchscreen/Mouse port,
and each time you switch between touchscreens, you must perform the
CALTOUCH command.
Digital Video Processor
Digital Video Processor: CNX- DVP4 • 91