Ink Refill Assy - Brother DCP-J552DW Service Manual

9.16 Ink Refill ASSY

Tip When the head/carriage unit has not been removed, refer to
Timing Belt, and Leveler Roller ASSY"
head/carriage unit.
(1) Remove the ink supply tubes (4 tubes) from the tube guide on top of the tube support plate, take
out the sponge, and remove it from the tube support wire.
(2) Take out the ink absorber box from the lower cover.
Tip When the main PCB has not been removed, disconnect the ink sensor flat cable from the main
PCB.
(3) Remove the ink sensor flat cable from the lower cover cable guide.
(4) Take out the ink refill ASSY.
Ink supply tubes
Black
Yellow
Cyan
Magenta
Tube guide
Tube support plate
Head joint
Ink sensor flat cable
Lower cover
in this chapter to remove the ink supply tubes from the
Ink cartridge detection
sensor PCB
Sponge
Tube support wire elbow
3-71
"9.3 The Head/Carriage Unit, CR
Ink Refill ASSY
Ink absorber box
Ink remaining sensor
flat cable cable guide
Tube
clamp (1)
Tube
clamp (2)
Black
Yellow
Cyan
Magenta
(3_096)
Confidential