Brother DCP-J552DW Service Manual page 46

First Line
Hub is Unusable
Image too Long
Image too Short
Ink Absorber Full
Ink Absorber Near
Full
Ink Low
Install Starter Ink
Low Temperature
Media Error
Media is Full
No Caller ID
No File
No Ink Cartridge
No Paper Fed
No Response/Busy
Out of Fax Memory
Out of Memory
Paper Jam
Touchscreen Init.
Failed
Unable to Print
Unable to Scan
Status
A USB device equipped with a USB hub or a hub
is set.
The image cannot be corrected because it is too
large.
The image cannot be trimmed because it is too
small.
The purge count or flushing count reached the
upper threshold.
The purge count or flushing count will soon reach
the upper threshold.
The ink remaining sensor detected that the ink
replacement period is approaching.
A cartridge without the necessary ink volume for
initialization was loaded during initialization.
The head thermistor detected that the room
temperature is too low.
A problem was detected in the memory card.
The memory of the media slot is full, or there are
999 or more files in the memory.
There is no Caller ID information.
There are no printable files in the memory card or
the USB flash memory.
No ink cartridge loaded.
The registration sensor detected that there is no
recording paper in paper tray 1.
The receiver is busy or there was no response.
The amount of accumulated data in the memory
through Memory Receive exceeded the limit.
There is not enough memory.
The registration sensor, paper width sensor, and
CR encoder sensor detected a paper jam.
After the power was turned on, the screen was
touched before touch panel initialization could be
completed.
Some problem occurred during printing.
Some problem occurred during scanning.
2-13
Error
Reference
Code
2-82
46
2-34
24
2-22
2A, 2B,
2-24
2C, 2D
2-52
2-82
2-84
2-84
0E, 18, 31,
2-19,
38, 3C, 82,
2-20,
84, 8A, 8C
2-27,
2-29,
2-30,
2-41,
2-42,
2-43
ED
2-51
Confidential