9.20 Components On The Engine Unit - Brother DCP-J552DW Service Manual

9.20 Components on the Engine Unit

CR encoder strip
(1) On the left end of the CR frame, press the rear end of the encoder strip spring inward and
remove the left and right end of the CR encoder strip from the hook.
(2) Rotate the CR encoder strip in the direction of the arrow shown below. Remove it after aligning
the left end square opening with the boss-shape of the strip support.
Note Be careful not to damage the CR encoder strip. If the strip is stained or damaged, replace it
with a new one.
Strip support
Assembling Note Attach the CR encoder strip with the end with the
motor side) and the
CR encoder strip
Encoder strip spring
mark facing upward. (Refer to illustration above.)
3-82
Pointing upward
CR frame
(3_092)
mark on the right (carriage
Confidential