Part 1: Fpga Development Board Introduction - Alinx ZYNQ7000 FPGA User Manual

Part 1: FPGA Development Board Introduction

The entire structure of the AX7Z100 FPGA development board is inherited
from our consistent core board + carrier board model. A high-speed inter-board
connector is used between the core board and the carrier board.
The core board is mainly composed of ZYNQ7100 + 4 DDR3 + eMMC +
QSPI FLASH. The ZYNQ7100 uses the Xilinx Zynq7000 series of chips, model
XC7Z100-2FFG900. The ZYNQ7100 chip can be divided into Processor
System (PS) and Programmable Logic (PL). On the PS and PL sides of the
ZYNQ7100 chip, two DDR3s are mounted, each with a DDR3 capacity of up to
512 Mbytes. The ARM system and the FPGA system can independently
process and store data. The PS-side 8GB eMMC FLASH memory chip and
512Mb QSPI FLASH are used to statically store ZYNQ's operating system, file
system and user data.
The AX7Z100 carrier board expands its rich peripheral interface, including
one PCIex8 slot, four SFP interfaces, two Gigabit Ethernet interfaces (one for
PS and one for PL), four USB2.0 HOST interfaces, one HDMI output interface,
one HDMI input interface, and one UART serial interface. 1 SD card interface,
40-pin expansion header and some buttons.
6 / 61
ZYNQ FPGA Development Board AX7Z100 User Manual
Amazon Store: https://www.amazon.com/alinx