Table of Contents
Advertisement
12 Electrical connection
12.1.2
Arm system selection
Factory set arm configuration is PUSH 210 mm, if other is required:
Select arm configuration on the DIP-switches according to the table below.
Type of arm system
Pushing
Pushing
Sliding push/Offset pivot
Sliding push
Sliding push 180 degrees
Sliding push 180 degrees
Sliding push 180 degrees*
Pulling PULL
Pulling PULL
Pulling PULL (narrow doors)
Pulling PULL/PAS
Pulling PULL/PAS
Folding door
Concealed (With panic
switch)
Concealed (Without panic
switch)
*
- Only low energy mode
- Max. door inertia 45 kgm
- Decreased opening and closing speed
Note! The Panic Break Out Switch, shall be a normally closed contact, and is only needed at the
Concealed inswing application.
Note! After changing any system selection a new LEARN must be carried out.
Note! If an undefined combination of AS1-AS4 is selected, then PUSH 210 mm is used as default.
52
Spindle location (hinge to outgoing spindle)
PUSH, 210 mm
PUSH, 95 mm
PULL 95, 95 mm
Distance (Reveal + Door thickness + hinge) = 0-80 mm
PULL 210, 210 mm
Distance (Reveal + Door thickness + hinge) = 75-130 mm
Reveal 0-100 mm
Reveal 100-200 mm
Reveal 200-305 mm
PULL, 210 mm Reveal 0-65 mm
PULL, 210 mm Reveal 65-130 mm
PULL, 95 mm Reveal 0-65 mm
PULL, 95 mm Reveal 0-65 mm, opening angle up to 180 degrees
PULL, 95 mm Reveal 65-130 mm
2
Issue 2021-02-24
ON=1 OFF=0
AS 1
AS 2
AS 3
AS 4
DIP 5
DIP 6
DIP 7
DIP 8
0
0
0
0
1
0
0
0
0
1
1
1
1
0
1
1
0
0
1
0
1
0
1
0
0
1
1
0
0
0
0
1
1
0
0
1
1
1
0
0
0
1
0
1
1
1
0
1
1
1
1
1
1
1
1
1
1
1
1
0
1009728-en-9.0
Advertisement
Table of Contents
