Electrolynx Connector System Notes - Assa Abloy Corbin Russwin PED5000 Series Installation Instructions Manual

PED4000/PED5000 Series Exit Devices
with optional connections
Installation Manual

ElectroLynx Connector System Notes

4
The system is designed to be installation friendly with quick connectors from the electric hinge
through the door to the rail. The only wiring required is to the loose wires on the pigtail harness
assembly on the frame side of the electric hinge.
Important: The plug and receptacle connectors are designed to mate and lock together as shown in
the figure. Plug the connectors into each other with the locking mechanism aligned as indicated.
Do not force connectors on any other way .
These notes apply to all of the following devices concerning the installation and wiring to the
ElectroLynx Connector System
1. With new applications, a raceway harness with 8 and 4 pin connectors will be pre-installed inside door by ASSA
ABLOY door manufacturer when specified during the ordering process. Raceway harness kits are also available
for retrofit applications.
2. If door does not have a raceway harness with connectors, cut connectors off product, or consult factory for
raceway retrofit kit.
3. Wiring to pigtail harness is per facility wiring requirement. The rail, raceway, electric hinge and pigtail connec-
tor terminations and wire colors all match.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2023 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or in
part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Locking mechanism
Receptacle
Plug
4
FM575 01/23