Impulses; Open/Close Impulse - Assa Abloy SW200 Installation And Service Manual

Hide thumbs Also See for SW200:

Table of Contents

reset, when the batteries have been replaced. It is done by pressing the Learn button, while

battery mode is active (mains disconnected).

Note! If battery mode is POWER SAVE, the reset has to be made during the door is opened by

Key impulse.

• During POWER FAILURE the operator will finish the actual operating cycle and then switch of

the battery supply. The battery powered operator can be reactivated to achieve a new operating

cycle by an impulse on the KEY input.

• The operating mode during battery power can be changed from POWER SAVE to CONVENIENCE,

see page 71. During CONVENIENCE MODE the operator will work as normal until the batteries

are discharged. The batteries are rechargeable and will be charged by the control unit in the

operator. New, fully charged batteries can typically open and close a door max. 300 times in

convenience mode. In power save mode the operator can stand-by in up to 1 week, waiting for

KEY impulse.

The following sensors are not active during battery operation POWER SAVE mode.

- Mat

- Overhead presence detector (OPD/OPS), frame mounted

- Presence impulse approach, door mounted

- Presence detection swingpath, door mounted

Note! All sensors works normally in CONVENIENCE MODE.

5.5.6

Impulses

• Input for OUTER impulse, KEY impulse and OPEN/CLOSE impulse.

5.5.7

The impulse will open the door and the door will stay open until a new impulse is given. If no impulse

is given the door will close after 15 minutes. This can be made infinite by changing group of para-

meters, see page 71.

OPEN/CLOSE impulse works only in program selection AUTO. Can be programmed for OFF and EXIT

as well,

see page

1009728-en-9.0

71.

Issue 2021-02-24

5 How the ASSA ABLOY SW200 works

Table of Contents