JLG TOUCAN 1010 Service Manual page 88

8
LOCATION LUBE TYPE
MOBIL DTE 16M
Viscosity : 68 cSt at 40°C
2. Lifting chains
Viscosity index : 142
Pour point : -45°C
3. Wheel
MOBILUX EP2
bearings (non-
(Lithium base grease)
drive hubs)
4. Swing MOBILUX EP2
bearing race (Lithium base grease)
MOBIL DTE 13M
5. Main
Viscosity : 32 cSt at 40°C
hydraulic
Viscosity index : 155
reservoir
Pour point : -48°C
Element replacement interval : After first 50 hours of operation and every 250 hours thereafter.
6. Return filter
7. Pressure
Element replacement interval : After first 50 hours of operation and every 250 hours thereafter.
filter
MOBIL DTE 13M
8. Steering unit Viscosity : 32 cSt at 40°C
reservoir Viscosity index : 155
Pour point : -48°C
MOBILTAC 81
9.Swing bearing
or
internal gear
MOBILITH SHC 1500
88
LUBRICATION
LUBE INTERNAL LUBE AMOUNT
Every 125 hours or
once every 30 days of
operation or more often
if the platform is used
or stored in a very
dusty or corrosive
environment.
Every 250 hours of
operation.
Every 250 hours of
operation.
- Check daily.
- Drain after 1000
hours of operation or at
least every 2 years.
- Check every 125
hours of operation.
- Drain after 1000
hours of operation or at
least every 2 years.
Every 1000 hours of
Coat all teeth.
operation.
APPLICATION
Lubricant can be applied
manually with a brush or by
spraying.
Apply lubricant :
- Longitudinally = in areas where
N/A joints are under small load to
facilitate penetration of the
lubricant.
- Transversally = between the
plates to enable the lubricant to
reac
1 Grease nipple
on each hub
N/A
1 Grease nipple on turntable base
plate
N/A
Fill through top in-tank return
filter.Check
21,5 l level through the
sight gauge on
the reservoir.
Check level/fill through reservoir
1l
breather cap.
1- Remove swing gear box
2- Apply a thick coat of grease
with a brush through the gear box
centering hole. Manually rotate
the turntable to reach the whole
teeth.
T o ucan 1010
8
MAX
MIN
Model
Révision 04-2006