JLG TOUCAN 1010 Service Manual page 61

6 ELECTRICAL CONTROLS DEVICE
Description and parameters values for Toucan 1010 models.
Parameter Description
Speed 1 Speed n°1 (variable)
Speed 2 Speed n°2 (variable)
Speed 3 Speed n°3 (variable)
Speed 4 Speed n°4 (variable)
Speed 5 Speed n°5 (variable)
Speed 6 Speed n°6 (variable)
Calibrator use as measuring instrument :
BATT V :
The measure of battery voltage can be done at any time,
even when the work platform is in operation, thus
enabling analysis, if necessary, of the battery voltage
fluctuations.
MOTOR V :
The measure of the motor voltage in operation enables
the determination, for a chosen speed, of the voltage to
be applied at the motor terminals. The value of this
voltage calculated in percentage of the battery voltage
determines the speed setting.
MOTOR AMP. :
The measure of the current at the motor enables the
determination of the current limit value to which the
controller must be set when the machine is driven on a
ramp.
TEMP °C :
The measure of the temperature enables the analysis of
the controller temperature increases, therefore the
operating conditions of the work platform.
Models
Toucan 1010
Edition 04-2006
Values
Unit Step
Groupe Centrale
Bosch Advanced
% 1% 45%
% 1% 45%
% 1% 45%
% 1% 50%
% 1% 80%
% 1% 100%
Comments
Mast lowering movement.
43% Make-up flow to hydraulic wheel motor.
Jib lowering movement.
43% Slewing movements.
43% Drive in slow speed
50% Jib raising movement.
80% Mast raising movement
100% Drive in high speed
6
61