JLG TOUCAN 1010 Service Manual page 30

4
4.2.3 "Westinghouse-SGTE" charger.
c
a
Charger panel
a. Default LED indicator (red).
b. Charger ON LED indicator (orange).
c. End of charge LED indicator (orange).
d. Stop switch.
e. Equalisation function button (green).
Power supply : 110VAC - 60Hz / 220VAC - 50Hz
- Adaptation to network voltage :
Troubleshooting
The default LED indicator lights up :
PROBABLE CAUSE
Voltage above 3V per cell (corroded plates)
Voltage below 1,8V per cell after 5 minutes charge.
Note : If the voltage is below 1,5V per cell, the
charger will not detect the battery.
Voltage does not reach 2,4V per cell after 11 hours
charge (Soft timer #1).
Charging time exceeds 15 hours (Voltage above
2,4V per cell) (Soft timer #2).
Charging time exceeds 16 hours (Hard timer).
30
BATTERY - CHARGER
e
b
d
DANGER
Prior to any operation requiring charger
cover removal, th e battery must be
disconnected and the charger must be
unplugged from the AC outlet. Failure to do
so could result in death or serious injury to
personnel.
- Connections on auto-transformer and transfor-
mer inlet terminals block :
220 VAC - 50 Hz :
Auto-transformer
220 V
Pre-
é
insulated
110 V
terminal
0 V
110 VAC - 60 Hz :
Auto-transformer
220 V
é 110 V
Pre-
insulated
0 V
terminal
- Protections :
Single pole thermal circuit breaker 20 Amps.
Output fuse : 100 Amps
AC auxiliaries : 2 Amps
Default LED indicator
! CAUTION
If a fault occurs during charge, switch off the
charger and disconnect it from AC outlet.
SOLUTION
Depress the equalising function button to resume
charge. (The default LED indicator flashes).
Depress the equalising function button to resume
charge. (The default LED indicator flashes).
Check condition of battery - connections and
charger. Disconnect the charger from the battery
and connect it again. If the problem persists, contact
JLG Product Support.
T o ucan 1010
Transformer terminal block
Transformer terminal block
Model
Révision 04-2006
4