JLG TOUCAN 1010 Service Manual page 6

ELECTRICAL CONTROLS DEVICE
Overload detection setting ---------------------------------------------------------- 6.1
Tilt alarm --------------------------------------------------------------------------------- 6.2
Battery discharge indicator setting ----------------------------------------------- 6.3
Circuits protection --------------------------------------------------------------------- 6.4
Façade circuit-breaker ------------------------------------------------------------- 6.4.1
Resetable fuses ----------------------------------------------------------------------- 6.4.2
Fuses on board ------------------------------------------------------------------------ 6.4.3
Power circuit fuses ------------------------------------------------------------------ 6.4.4
Devices modifying the machine's performance ------------------------------ 6.5
Mast switch --------------------------------------------------------------------------- 6.5.1
"5 m" mast switch ------------------------------------------------------------------ 6.5.2
Steering limit switch ---------------------------------------------------------------- 6.5.3
Drive limit switch -------------------------------------------------------------------- 6.5.4
Safety features - Movement cut out ------------------------------------------- 6.5.5
Speed electronic controller --------------------------------------------------------- 6.6
Help with the diagnosis -------------------------------------------------------------- 6.7
Electronic modules -------------------------------------------------------------------- 6.8
Controls verification module ------------------------------------------------------ 6.8.1
Drive management module --------------------------------------------------------- 6.9
"Clipper" connector installation procedure ----------------------------------- 6.10
PREVENTIVE AND MAINTENANCE INSPECTION
General ------------------------------------------------------------------------------------ 7.1
Preventive maintenance and inspection required ---------------------------- 7.2
Daily preventive maintenance and inspection ------------------------------- 7.2.1
Weekly preventive maintenance and inspection --------------------------- 7.2.2
Monthly preventive maintenance and inspection -------------------------- 7.2.3
Every 125 hours of operation preventive maintenance and inspection - 7.2.4
Every 250 hours of operation preventive maintenance and inspection - 7.2.5
Every 500 hours of operation preventive maintenance and inspection - 7.2.6
LUBRICATION
Lubrication points ---------------------------------------------------------------------- 8.1
6
TABLE OF CONTENTS
T o ucan 1010
6
7
8
Model
Révision 04-2006