JLG TOUCAN 1010 Service Manual page 78

6 ELECTRICAL CONTROLS DEVICE
Check the red plate is correctly inserted in the black
connector body.
If the terminal is hard or impossible to push in, check
the contacts are correctly inserted in their housing
with rounded pliers.
- screw in the rear part of the connector while
holding the red terminal block in place (a). Lock
the elbow (b). Push the cable towards the inside
of the connector (c). Tighten the gland (d).
Ensure the contacts are flush with the top of
the connector (e). Check the position of the
dummy studs in order to have the bent elbow
inserted in the opposite plug (f).
78
NOTE
If impossible to correctly wire the connector,
remove the red retaining plate : locating
sprockets should not be broken.
b r o k e n
sprocket
T o ucan 1010
6
Model
Révision 04-2006