Alpha ESS Storion-SMILE-T10 Installation Manual page 25

Figure 19 Fixing the Rear Bracket of HV50056
Step 7: Fix the HV50056 rear bracket as shown in Figure 19.
1 Find the positioning point and mark it.
2 Use the impact drill (drill φ10.0mm, length 20cm) to directly drill the hole in the
marking position of HV50056 rear bracket, the depth of the drilled hole should be
7cm.
3 After the drilling is completed, insert the expansion tube into the drilled hole, and
fix the rear bracket with a 10mm self-tapping screw by using 10MM sleeve (SW10).
4 Fix the HV50056 box rear bracket with the flange nut and use a 7MM sleeve on the
two L-shaped brackets of the battery (SW7).
Note: Place the PE bag on the battery to block out the dust before drilling.
24 / 55