Alpha ESS Storion-SMILE-T10 Installation Manual page 23

Step 3: Use a screwdriver to assemble the battery mounting bracket onto the outside
of the battery, as Figure 15 shows.
Step 4: Confirm the installation place at first.
Push the battery against the wall and confirm the location of the battery with a
horizontal ruler.
Place the PE bag on the battery to block out the dust before drilling.
Please drill four holes (two on each side) directly on the wall at the marking positions
of the brackets with an impact drill (bit φ 8.0mm, length 20cm), and the depth of
each hole should be about 7 cm.
Figure 15 Assembling Battery Brackets
Figure 16 Placing Battery
22 / 55