Figure 3-7 Example Of Video Loss - Gatekeeper Y58 User Manual & Installation Manual

Y58 User Manual & Install Guide
corresponding camera. This will switch the display to Single Camera On-screen View to display
the video from the selected camera.
Once you have selected a channel to view, you can cycle through the available channels
iteratively in quad grid display mode by pressing the key zero [0] on the ICD2.
9 Camera On-screen View
In 9 Camera On-screen View mode, the screen is split into nine sections (using a 3x3 grid layout)
and video from all connected cameras is simultaneously shown on the screen.
To select a specific camera for viewing, you may press any of the keys [1-8] on the ICD2 to
immediately jump to that channel and display the video stream from the corresponding camera.
This will switch the display to Single Camera On-screen View to display the video from the
selected camera.
Alternatively, with the Finger Mouse or the ICD2, you could also click on any video stream on
the quad grid display to immediately jump to that channel and display the video from the
corresponding camera. This will switch the display to Single Camera On-screen View to display
the video from the selected camera.
Channels that do not have cameras configured on them will just show a black display.
Any channel which is configured with a camera, but is not receiving any video signal from
that camera will show a Video Loss message on the screen.
Notes

Figure 3-7 Example of Video Loss

27 of 148