Gatekeeper Y58 User Manual & Installation Manual page 118

Y58 User Manual & Install Guide
Channel – checkboxes which allow you
to select any combination of the
camera channels to be included in the
display and recording.
Post Recording – numeric value box
which allows you to enter the duration
for which video will continue to be
recorded when the alarm is triggered.
Lock – checkbox, if selected will mark
the recorded video associated with this
alarm as locked video.
3G Network – checkbox, if selected
will enable alarm notification over the
3G network.
Linkage IO Output – checkboxes, if
enabled, the device will send a signal
to the selected IO output lines.
Output Delay Time – numeric text
field to set the delay time for the IO
output (in seconds).
Alarm Upload – checkbox, if selected
will enable the device to upload the
alarm to the centre server.
Linkage Screen – drop-down list to
select the options to display the video
from the selected cameras on-screen
when the alarm occurs.
None : Not displayed
Single : Display 1 camera.
Dual : Display 2 cameras.
Quad : Display 4 cameras.
If Single (1x1) or Quad (2x2) display is
selected, the (Setup) button allows
you to select the layout of the channels
to be displayed on-screen.
The drop-down lists are shown on-screen
accordingly to the grid layout mode
selected. You can easily choose each
individual camera channel to be displayed
in the selected grid segment visually. If you
have less cameras than available grid
segments, then those segments associated
with an actual camera will be displayed as
a black box.
PB Alarm Duration – numeric text
field to set the duration of the video
118 of 148