Gatekeeper Y58 User Manual & Installation Manual page 125

Y58 User Manual & Install Guide
GEO Fence
DEFAULT SETTINGS:
Area I/O Alarm DEFAULT SETTINGS:
Switch
Line I/O Alarm DEFAULT SETTINGS:
Switch
Skew Alarm Switch DEFAULT SETTINGS:
Driving Alarm DEFAULT SETTINGS:
Switch
will continue to be recorded when the alarm is
triggered.
Lock – checkbox, if selected will mark the
recorded video associated with this alarm as a
locked video.
Linkage IO Output – checkboxes, if enabled,
the device will send a signal to the selected IO
output lines.
Output Delay Time – numeric text field to set
the delay time for the IO output (in seconds).
Linkage Screen – drop-down list to select the
options to display the video from the selected
cameras on-screen when the alarm occurs.
None : Not displayed
Single : Display 1 camera.
Dual : Display 2 cameras.
Quad : Display 4 cameras.
If Single (1x1), Dual (2x1), or Quad (2x2) display is
selected, the (Setup) button allows you to select the
layout of the channels to be displayed on-screen.
The drop-down lists are shown on-screen according
to the grid layout mode selected. You can easily
choose each individual camera channel to be
displayed in the selected grid segment visually. If
you have less cameras than available grid segments,
then those segments associated with an actual
camera will be displayed as a black box.
PB Alarm Duration – numeric text field to set
the duration of the video playback (in seconds)
when the alarm occurs.
Alarm Snap – checkbox – if selected, when the
alarm occurs, the device will take snapshots
using the selected cameras.
Disabled.
Checkbox – unselected
Checkbox – unselected
Checkbox – unselected
Checkbox – unselected
125 of 148