Gatekeeper Y58 User Manual & Installation Manual page 113

Y58 User Manual & Install Guide
Early Difference: Numeric field to key in a value for when the vehicle goes over a specified
speed prior to the actual speed limit.
Speed: Numeric field to key in the speed value over which the device will flag an over speed
alarm.
Alarm Duration: Numeric field to set the duration of the alarm (in seconds).
Save Settings: Click the (OK) button to save the alarm settings.
Back to Previous: Click the (Cancel) button to return to the previous screen without saving.
Linkage Click the (Setup) button under Linkage to go
to the Linkage setup screen. This sets up the
video display, recording and snapshot options
associated with this alarm.
The Linkage setup screen enables you to
configure the following options:
Channel – checkboxes that allow you
to select any combination of the
camera channels to be included in the
display and recording.
Post Recording – numeric value box
which allows you to enter the duration
for which video will continue to be
recorded when the alarm is triggered.
Lock – checkbox, if selected will mark
the recorded video associated with this
alarm as a locked video.
Linkage IO Output – checkboxes, if
enabled, the device will send a signal
to the selected IO output lines.
Output Delay Time – numeric text
field to set the delay time for the IO
output (in seconds).
Linkage Screen – drop-down list to
select the options to display the video
from the selected cameras on-screen
when the alarm occurs.
None
Single
Dual
Quad
: Not displayed
: Display 1 camera.
: Display 2 cameras.
: Display 4 cameras.
113 of 148