Gatekeeper Y58 User Manual & Installation Manual page 126

Y58 User Manual & Install Guide
T&H Sensor
Section Limit Speed DEFAULT SETTINGS:
TTS Switch
Name T-Sensor1, name of the Sensor.
Enable DEFAULT SETTINGS:
Alarm Type DEFAULT SETTINGS:
Alarm
Trigger High Temp. Thresh
DEFAULT SETTINGS:
Temp. Increase Warn Time
DEFAULT SETTINGS:
Temp. Increase Difference
DEFAULT SETTINGS:
Debounce Time – multiple alarms of the same resource
active within the debounce time frame are regarded as
one alarm.
DEFAULT SETTINGS:
Linkage Click the (Setup) button under Linkage to go to the
Linkage setup screen. This sets up the video display,
recording and snapshot options associated with this
alarm.
The Linkage setup screen enables you to configure the
following options:
Checkbox – unselected
Checkbox – unselected
284° F
10 Minutes
154° F
10 Seconds
Channel – checkboxes that allow you to select
any combination of the camera channels to be
included in the display and recording.
Post Recording – numeric value box which
allows you to enter the duration for which video
will continue to be recorded when the alarm is
triggered.
Lock – checkbox, if selected will mark the
recorded video associated with this alarm as a
locked video.
Linkage IO Output – checkboxes, if enabled,
the device will send a signal to the selected IO
output lines.
126 of 148