Erase Eeprom (Erase System Memory); Set Password - Pentair EasyTouch PNP 5 Owner's Manual

Erase EEPROM (Erase System Memory)

EasyTouch system configuration data is stored and retained in "Flash" memory in an EEPROM located on
the control panel motherboard and optional Indoor Control Panel. The EasyTouch user system configuration
data can be erased to restore the factory defaults settings. System information automatically downloads
from programmed components to non-programmed components in case of accidental memory loss and to
ease board replacement. Any optional controllers (iS4, SpaCommand and QuickTouch QT4 controller) that
were configured need to be reconfigured.
Erase EEPROM
The following procedure describes how to erase the system memory from either the main EasyTouch
control panel or the EasyTouch Indoor Control Panel.
CAUTION: This procedure will erase all system settings. Any optional controllers will need to be
reconfigured.
Getting There
MENU SETTINGS Erase EEPROM
Erase EEPROM

Erase ALL? No (Yes)

Erase EEPROM

Are You Sure?
No (Yes)

AUTO HEATER
SPA 35°C / 38°C
AIR 20°C
MON 09:30 AM

Set Password

If required, the password feature allows you to password protect the EasyTouch control panel. To access a
password protected control panel, you must enter the correct four digit password before access is granted.
Password
To enable the password protect feature:
Getting There
MENU  SETTINGS  SET PASSWORD
Set Password

PW : [0000]
Enable : No

Erase EEPROM
Up/Down button: Select Yes.
Right button: The message "Erase EEPROM Are You Sure? No" is displayed.
Up/Down button: Select Yes.
Right button: Press this button to erase system data and restore the factory
defaults. The display will go blank, then the main screen will be displayed.
Up/Down button: Select the password first digit (0-7) of the four digit
password.
Right button: Select the next password digit. Repeat the previous step to
enter each of the password digits.
Right button: After you are finished entering the four password digits, press
the Right button to enable the password feature.
Up/Down button: Select Yes enable the password feature.
Press the Menu button three times to save the settings and to return to the
main screen.
Note: If the password feature is enabled, the current four digit password can
be viewed from the EasyTouch outdoor control panel in the "Set Password"
setting.
Advanced Settings: Erase EEPROM
Page 55